What Should You Check on a Floor Plan Before Buying in Berlin?

Before you make an offer on a Berlin flat, check four things on the Grundriss: that your furniture fits the rooms at the sizes shown, that you keep 90 cm to walk past it, that the kitchen and bathroom can stay where they are, and which walls the seller says are structural. A plan answers the first three in an hour. Only a building engineer can answer the fourth.

Most buyers do it the other way round. They fall for the flat at the viewing, make the offer, and only then ask whether the sofa fits. By that point the plan is a document to file, when it should have been a tool to use.

Does your furniture fit the rooms on the plan?

Start with what you own, not what you might buy. Measure the three or four pieces that decide a room: the bed, the sofa, the dining table and the largest wardrobe. Draw them onto the plan at the same scale, or print it and cut out paper rectangles.

Then keep four clearances, because they are the difference between a room that works and one you squeeze through: 90 cm for a main walkway, 45 cm between a sofa and a coffee table, 90 cm behind a pulled-out dining chair, and 90 cm in front of a wardrobe or chest of drawers. Below about 75 cm, people turn sideways.

Check the scale before you trust anything. Brochure plans often draw furniture smaller than it is, and some carry no scale bar at all. A bedroom shown as 3.2 by 3.9 metres sounds roomy. Put a 200 cm bed against the end wall, a wardrobe 60 cm deep opposite, and leave 90 cm in front of the wardrobe, and you need 200 + 60 + 90 = 350 cm along the room. That works along the 3.9 m side with 40 cm to spare. Along the 3.2 m side it is 30 cm short. Do this sum for every room before the viewing, not after.

How do you read a Grundriss?

A Grundriss is the flat seen from above, as if the roof had been lifted off. Thick lines are walls, thin lines are partitions or fittings, an arc shows which way a door swings, and a gap in a wall with parallel lines is a window.

The number to question is the area. Wohnfläche is the calculated living area, and it is not the same as floor you can use. A balcony is often counted at a quarter of its area and sometimes at half. Floor under a sloping roof counts at half between 1 and 2 metres of headroom and not at all below 1 metre. Ask how the seller worked the figure out. Two flats advertised at 68 m² can differ by several square metres of usable floor.

Can the kitchen and bathroom stay where they are?

Wet rooms are where the plan matters most. The pipes for a kitchen and a bathroom usually run in a shaft or along one wall, and the further a sink, toilet or shower sits from that line, the harder the move becomes.

On the plan, find the Schacht, the shaft, often drawn as a small hatched box, and note which rooms share a wall with it. If your ideal layout puts the kitchen at the opposite end of the flat, treat that as a question for a plumber, not a styling choice. We design around what the plan shows and bring in the owner's own plumber or engineer for what it does not.

Which walls can you take out?

The plan will not tell you. A thick wall is a hint, not a fact. In an Altbau, a brick wall of 24 cm or more may be structural, while a 10 cm partition usually is not, but the only reliable answer comes from the building drawings and an engineer.

If you own the flat, a wall may also need the agreement of the owners' association, and a listed building adds the heritage authority. Ask the agent for the building documents, ask the Hausverwaltung what has been approved before, and ask a structural engineer before anyone prices the work. We do not give structural or legal advice. Where a project touches the building itself, we work alongside the owner's own engineer or can introduce a trusted partner.

What does a floor plan not show?

Ceiling height, light, noise, radiators and sockets. Altbau ceilings of 3.2 to 3.5 metres change how a room feels and how much heat it needs, which we cover in how to make a Berlin Altbau feel warm in winter.

Take a laser measure to the viewing and check three things. First, the real width of each room against the plan. Second, where the radiators are, because a radiator under the only free wall decides where the sofa goes. Third, which way every door and window opens. Photograph each wall straight on so you can redraw it at home.

A worked example: a 62 m² two-room flat

On the plan the living-dining room is 4.2 by 6.2 metres, about 26 m². The buyer owns a 220 cm sofa and a 110 by 60 cm coffee table, and wants a dining table for four.

The sofa group first. A sofa 95 cm deep, 45 cm of gap and a table 60 cm deep add up to 200 cm across the 420 cm width, which leaves 220 cm. A media unit 40 cm deep on the opposite wall leaves 180 cm, so a 90 cm walkway fits with 90 cm to spare.

Along the 620 cm length, the sofa group takes 300 cm, a 220 cm sofa plus 40 cm each side, which leaves 320 cm for dining. A 160 by 90 cm table leaves 80 cm at each end, below the 90 cm we want. A 140 by 80 cm table leaves exactly 90 cm. Across the room, an 80 cm wide table with 140 cm either side needs 360 cm of the 420 cm, because a chair pulls out about 50 cm and you want 90 cm behind it.

So the flat works, but only with the smaller table. That took ten minutes and a brochure, before any offer was made.

Where the popular advice fails

Comparing price per square metre hides the area calculation and the shape of the rooms. A 60 m² flat with a 7 metre corridor can live smaller than a 55 m² flat with none.

Assuming a designer can fix any layout later is the costly one. We can rearrange furniture, light and storage inside the walls and pipes you have. We cannot style our way out of a flat where the kitchen cannot go where you planned, and the expensive discovery is making that finding after you have signed.

Open plan is not always the answer either. Taking a wall out removes the wall you needed for the sofa and the radiator, and in a high-ceilinged flat it can leave one large room that is harder to heat and harder to furnish than the two it replaced.

Studio Akiva has over 100 five-star reviews on Houzz, has been a Houzz member since 2017 and has won twelve consecutive Houzz awards, with residential projects completed in the UK, USA, Dubai and Saudi Arabia.

Quick answers

What is a Grundriss?

The floor plan of a flat, drawn from above. It shows walls, doors, windows and room sizes, and usually the Wohnfläche. It does not show ceiling heights, radiators or what is structural.

How much space do you need to walk around furniture?

90 cm for a main walkway, 45 cm between a sofa and a coffee table, and 90 cm behind a pulled-out dining chair. Below about 75 cm most people turn sideways.

Does the Wohnfläche include the balcony?

Often at a quarter of its area, sometimes at half. Ask the seller how the figure was calculated, because it changes the usable floor.

How can you tell if a wall is load-bearing?

You cannot tell from a plan. Ask for the building documents and the Hausverwaltung's records, and have a structural engineer confirm before you plan around removing it.

Want someone to read the plan before you make an offer?

Send us the Grundriss before we speak. In the Layout Clinic we spend ninety minutes on video, in English, working through the layout with you, and you get our reasoning in writing within 48 hours.

Featured photo: Lucas Kepner on Unsplash.

Previous
Previous

What Can You Actually Change in a Berlin Altbau Flat?

Next
Next

How Do You Make a Berlin Altbau Feel Warm in Winter?